POCKETZONE Quick Start Manual

LTI Laser NO ANGLE ENCODER
By George Maglaras San Diego Police Department

1. Turn on Recon by Pushing the Instant On/Off Button (lower right hand button).
2. Tap "Start" w/stylus upper left corner of screen of Recon Screen.
3. Tap "PocketZone LTI" to open program.
4. Tap inside Filename box, Tap on Keyboard symbol lower right corner of screen.
5. Type in your desired filename (user Defined)
6. Tap OK Button to save file as name you just typed.
7. Tap on File lower left corner of screen.
8. Tap on Laser Device select LTI No Angle Encoder.
9. Tap on OK Button
10. Instrument height box appears. Tap inside box, bring up keyboard and type in your instrument height.
11. Tap on Draw bottom of screen & Select LTI Triangulation Setup.
12. Tap on center of screen to set Control Point 1. tap anywhere on screen, it doesn't matter. The screen will automatically center itself once you shoot CP2.
13. Set height of CP1 Box appears. Tap in height box and then tap on keyboard symbol type your height. Then Tap on the "OK Button."
14. Make sure Laser is still turned on and set on Survey mode. You should see a triangle with a line under it. If not pull trigger of Laser then push Survey button on laser 1 time (right side of Laser)
15. Now line up with CP1 and Shoot to CP2. You should now have 2 Triangles with a red dashed line between them on your screen.
16. Tap on Draw bottom of screen and then TAP on LTI Triangulation.
17. Pick your Description from the drop down box.
18. Shoot CP1 first then CP2 second.
19. Pick Side appears on bottom of screen. Remember orientate yourself, the scene and your Recon screen and Pick the Proper side by Tapping on that side of the Control Points.
20. Choose yes to all this side. (You can always switch sides if evidence is also on the other side.
21. To switch sides Tap on Draw bottom of screen Tap on LTI Triangulation Reset side.
22. For Custom Descriptions "Tap" on Custom (Top of list of the descriptor field. Tap inside long empty box to place cursor. Tap on keyboard symbol lower right corner of screen. Type description. Then Tap on OK Button.
23. Tap on Draw lower portion of screen Tap on LTI Triangulation. You MUST ALWAYS DO THIS AFTER CUSTOM DESCRIPTIONS. Shoot CP1 then CP2.
24. When done shooting your scene you need to save the Point List and Save your job.
25. Tap on File, Tap on Save Point List a default screen appears, just Tap on the OK Button. Make sure Tabs is selected in the next box. Repeat 22 except Tap on Save Repeat again Tap on Exit. This will close program so you can copy file later to complete your drawing and print your field measurements.